Posted by: JERNAS SAM
How to give the Uniform load on the Header - 07/11/07 06:58 AM
Dear All,
I am new to C2,I modeled 6 metre lenth 10" pipe,which has numerous
1" pipe braches,now
1)How can i apply load of all branches without modelling the 1"pipe
2)Is there can we give uniform load?
If this question is silly please excuse me....
thanks,
regards,
sam.
I am new to C2,I modeled 6 metre lenth 10" pipe,which has numerous
1" pipe braches,now
1)How can i apply load of all branches without modelling the 1"pipe
2)Is there can we give uniform load?
If this question is silly please excuse me....
thanks,
regards,
sam.