isogen pipe diameters <= 14" BUG

excuse me,
have anyone reported this bug?
for pipe diameters <= 14", the isogen annotation system reports not correct informations.

for example, a 10" pipe is indicated as 254NS and not 273mm.

i've also tried to change the I-configure option "Units" in each of the three possibilities, but with no acceptable results. for example the 10" pipe is always indicated as 254NS.

Can you upload the c2 job that shows this behavior? (Use the [File Manager] option just below the "Full Reply" box.

The problem is that the nominal size is getting converted directly to "mm". We'll need to add some additional logic here to obtain the actual metric nominal.

tnx for your reply.
we are waiting for you!