Posted by: Michael_Fletcher
User Suggestion: Force Displays in Input Editor - 05/29/20 01:21 PM
I would recommend the way forces are currently displayed to be changed. As-is, we have only one force-set that shows up at a time, and you switch between them. I.e. only F1, F2, F3, F4, F5, F6, F7, F8, F9, etc.
I would instead prefer to see all of them at the same time, just change their primary colors to match the colorations of temperatures, pressures, diameters, etc (or some other variation - I'm not particular, here).
Of course, I'd also like to be able to hide individual sets... F1, F2, F3, etc, and this should also tie in with pipe visibility.
Presently, if you're placing relief loads in closed system analysis, you have to cycle through the force sets manually.
Also, these same arrows should get similar treatment as restraint arrows as to whether they should be pushed outside the pipe for viewing when they're in line with a pipe segment.
Thanks
I would instead prefer to see all of them at the same time, just change their primary colors to match the colorations of temperatures, pressures, diameters, etc (or some other variation - I'm not particular, here).
Of course, I'd also like to be able to hide individual sets... F1, F2, F3, etc, and this should also tie in with pipe visibility.
Presently, if you're placing relief loads in closed system analysis, you have to cycle through the force sets manually.
Also, these same arrows should get similar treatment as restraint arrows as to whether they should be pushed outside the pipe for viewing when they're in line with a pipe segment.
Thanks