Posted by: uday
code check not occuring at tee junctions - 10/17/18 03:16 AM
Hello members,
Recently i ran a pipe stress file and found that codal check is not performed only at tee locations (allowable stress is zero at 3 tee nodes).I was using AMSE NC for codal check.Checked the material file it is ok. But in earlier analysis,i have not faced this issue.I am unable to locate the cause of this problem.Can any one suggest the reason and solution behind this.
Recently i ran a pipe stress file and found that codal check is not performed only at tee locations (allowable stress is zero at 3 tee nodes).I was using AMSE NC for codal check.Checked the material file it is ok. But in earlier analysis,i have not faced this issue.I am unable to locate the cause of this problem.Can any one suggest the reason and solution behind this.