Error message

Dear All,

Please note we are getting below message each time error check is being done.

"The node number 58320 must be less than 32000 and greater than zero"

We have node numbers ranging from 10-8340. We checked in whole model we don't have any node number following in above error category.

Please let us know how to resolve this error.

Regards,
Avinash

Maybe you have a restraint named 58320 or a cnode or something else.
Most probably near 8320.
Some typing mistake.

If you double click on the error it will take you to that element then take a look at ells cnodes etc on this card. I not there then try the cntl F with 58320 to attempt to find

Hi,

I have tried to locate node no. 58320 by all methods as mentioned above threads. When I double click error it takes to first element & there is no such node no.

Even I tried deleting first element followed by error check, even then same error appeared. And it takes to first element of model.

Regards,
Avinash

Try sending the model out to the c2 Neutral file. You can edit (view) this file in NotePad.

If you can't find the source of the error, open a Support Request on Smart Support and send in the model file.

Thanks Richard, we could locate in notepad by opening C-II neutral file.
It was very easier to find in notepad.

Regards,
Avinash