Activation of flange temp in load case editor for comb case

Hi gents,
I started using 5.3 recently and when I tried to check flanges (NC-3658.3)for combined load case and appeared impossible as flange temp in load case editor in not active (disabled) it's only active for non-combined cases it was not like that in 5.2
Does any-one know how to make it active (enabled)

thanks in advance

Regards

Eldar

hi Eldar,

go to Edit static load case>>>load case options>>> last column flange analysis temperature. there you have to specify for which case you want to check flange leakage.

Hardik Pilojpara,
Rliance industries