Static Report Out put

In The Static Report sumary (stress) you can see the highest value and the node, but if go to the list report you will find that this value is lower. Could some one clarify me this issue?

In almost all cases, a node appears in the force/stress reports twice (since almost all nodes connect <em>two</em> pipes). If the node in question happens to be a tee, then it will appear in the force/stress reports three times.

Use the [Search] facility (the "binocular" icon) to search for the node. Keep searching until you find all occurances of the node. You will find the location referenced in the <em>Stress Summary</em>.

Well I checked the hole list but the value do not match with the indicated in the sumary. Althogh, for thermal stress this value is similar to the value listed in long report.

E-mail me your <jobname>._a and <jobname>._j files so I can run your job here. Please tell me which load case you're looking at and what values you see in your stress summary. I'll get back to you as soon as I see the results.

Ray,

Thanks for your answer, I fond the value and it is correct.

Thanks