Posted by: th1009
no allowable - 02/21/13 12:43 AM
hi all.caesar ii 5.30 output report shows allowable stress zero.any one can help me?
Posted by: Goodness
Re: no allowable - 03/05/13 12:22 PM
Hello
What`s your code?
and n what load case you have problem?
Posted by: SJ
Re: no allowable - 03/06/13 02:23 AM
I just hope you're not checking stresses for "Operating Cases" for B31.3.If that's the case, then you'll see zero stresses as Code doesn't define allowable (equstions) for that.If you want to check stresses in operating condition then use Appendix P which gives equations for Operating Stresses too!!!
Posted by: Richard Ay
Re: no allowable - 03/06/13 08:22 AM
Check
this previous post on this same subject.
(This particular post is a "sticky topic" near the top of the Forum, so it is easy to find.)
Posted by: somita
Re: no allowable - 03/09/13 03:48 AM
I have similar problem BUT not for operation(i know it's correct).for EXP and SUS it shows zero allowable and a huge percent (for example 1120%).help me please.
code is B31.3
COADE CAESAR II V5.30
recheck you input..(unit,thickness, weight of rigid , density of service&insulation etc)