Posted by: long_and_round
WRC107/297/PD5500 analysis - 05/03/12 02:36 AM
Quick query really as not used the WRC107/297/PD5500 analysis module before.
In the WRC107 module when I create a new WRC107 analysis I am shown the units file which is: mm, N, bar, degC etcetera. When I populate the field the bottom of the window states the units I am using which agrees with what expecting.
When I save the analysis and go back in later, the units have now changed to: in, lb/in2, degF etcetra but the numbers previously entered have not been changed.
Therefore, what was say 400mm is now 400in and 225degC is 225degF and so on.
Therefore, the results are not going to be correct. Not sure how to get around this as there doesnt seem to be a way of changing the units, any suggestions (maybe I am doing something wrong)?
Regards.
In the WRC107 module when I create a new WRC107 analysis I am shown the units file which is: mm, N, bar, degC etcetera. When I populate the field the bottom of the window states the units I am using which agrees with what expecting.
When I save the analysis and go back in later, the units have now changed to: in, lb/in2, degF etcetra but the numbers previously entered have not been changed.
Therefore, what was say 400mm is now 400in and 225degC is 225degF and so on.
Therefore, the results are not going to be correct. Not sure how to get around this as there doesnt seem to be a way of changing the units, any suggestions (maybe I am doing something wrong)?
Regards.