Posted by: El Maturin Pipe
Caesar II V 5.3 "include piping input file" - 03/15/12 06:08 AM
Hello,
I am trying include a caesar file inside of other, but show me a message "ERROR--Units incompatible with file" I am using the same unit files in both calculation, and convert the both files using the same unit file... So I donīt know what happen. With version 5.2 or 5.1 never I was that problem, with 5.3 version I canīt do it that.
My current version is 5.3 built 101122.
I have problem too when renumber the nodes, just change the node of first of fourt restriction.
Please any person could help me???
Regards,
GS.
Posted by: Richard Ay
Re: Caesar II V 5.3 "include piping input file" - 03/17/12 09:00 AM
Open a Support Request (SR) on eCustomer and send your job files in so Support can review this.
Posted by: El Maturin Pipe
Re: Caesar II V 5.3 "include piping input file" - 03/20/12 10:13 AM
Dear Richard, where can I open a SR... I was explore the
http://www.coade.com/Default.aspx and I canīt found the SR...
Posted by: Mpls_CAESAR_Guy
Re: Caesar II V 5.3 "include piping input file" - 03/26/12 10:51 AM
Fix to this issue:
Remove "Uniform Loads" definition from both files, save each again. Then attempt to combine using 'Input Piping Files' tool. Once combined, then go back and re-enter your Uniform Loads definition once again.
This worked for me, as I had some seismic loadings specified as Uniform Loads on my model. I recieved this fix from Loren Brown at Intergraph.
Posted by: Dave Diehl
Re: Caesar II V 5.3 "include piping input file" - 03/27/12 12:04 AM
No need for this work-around now. This incompatabilty has been corrected in SP-2.