Dear Delaforce,
Thank you very much for your attention.
Please let me explain my question again.
In the output of Pvelite, the nozzle summary section, after sumerizing nozzle in a table, Pvelite mentions Min of M.A.W.P for Nozzle and Shell&Flange.
My question is:
Is it crutial that we avoid falling of Min of M.A.W.P on nozzle.
For instance, it is necessary that M.A.W.P of nozzel be greater than M.A.W.P of shell&Flange.
I will appreciate if you let me know your answer.
Best Regards,
Naderi
_________________________
M.NADERI