I have line sloping at 1:200 and when I place an elbow, the elbow is trimmed but the description in CADWORX is the same as what is in the spec/catalogue. However if I place a line at a slope of 1:100 the elbow description will include TRIMMED at the start and the angle at the end, see below.

Elbow description at 1:100 = TRIMMED 90 ELL. BW, WROUGHT CS, SMLS OR WELDED, SCH 40, ASTM A234 (89.43)

Elbow description at 1:200 = 90 ELL. BW, WROUGHT CS, SMLS OR WELDED, SCH 40, ASTM A234

Is there a setting or tolerance that needs to be adjusted so they only have one description? I wan them both o be as the description for 1:200 slope. This question is for CADWORX model not isogen.