This might have been covered before, I'm not sure.

If I choose a linetype of HIDDEN (dashed) and select some pipe and set it to HIDDEN - why doesn't it print that way? I've played with LT SCALE (and it scales my regular lines, but not pipe), TILEMODE (no change), and just the Linetype scale in Properties. No luck. When I am in paperspace, looking at a view, I see the pipe as dashed, yet no matter what I try to do, it won't print it out that way.

Am I overlooking something?

I am trying to show underground and aboveground pipe. The underground would be dashed. I've been just tracing the underground pipe with a dashed line, then turning the layer off. I was hoping I could manipulate CADWorx, and CAD, somehow to where I don't have to do that anymore.

If the current release cannot do it, will the new release be able to do this?

Thanks

Take a look at the two post below

http://65.57.255.42/ubbthreads/ubbthreads.php?ubb=showflat&Number=28160&page=1

http://65.57.255.42/ubbthreads/ubbthreads.php?ubb=showflat&Number=35519&page=1