In one of our models, something strange is happening. This only occurs when using the copy and stretch command. Any one of you seen this before and if so, how do you stop it. It is not a problem to the drawing as it is a distraction.

At the bottom left, the progress bar. It appears when using the copy and stretch command. Any Clues.

What version of CADWorx are you using? I recall in the bowels of my memory that there was a build to correct this.

CADWorx Plant Professional 2010 (Build Date: November 10, 2010) (32 bit)

Do you have Clash Detection turned on?

It is turned off, but show clashes is selected. Also tried with clash off and hide clashes. Still no change.

Of course, I ran an audit and no change. Even a recover.