when ISOGEN, the equipment and nozzel tag never appear on the isometric drawing, any idea how to solve this?

thank you.

You have to model the equipment in CADWorx equipment.

ya all the equipment in cadworx equipment but I block it and use as xref

I'm not sure I follow why you block it? You can just use it as an xref.

For each piece of equipment we create a 3D model through CADWorx Equipment and save it on the network. Then we xref it into our piping model. Those are the only steps required to use it with Isogen.

Isogenbatch shows equipment nozzles on xrefs, Isogenout doesn't.

Tim Storey

Also, I think you'll want to set your UseObjectsFromXrefs variable to 1.

It will work in Isogenout as well, as long as the UseObjectsFromXrefs setting is turned on in CADWorx setup.

Also check switch 111 in your OPL, you can suppress nozzles.

Its work, thank you.