ERROR SUMMARY

In an assigned pipe specification, there are several (mostly in the standard 150 sizes category) components where the following command line error appears.

ERROR from command line follows:
FLGW
Data not found. Current Project:'Inch_CS_Specs_2020_02.prj', Specification:'150', Main Nom=2.000, Red. Nom=1.000
Error reading data for component: Type=Flange Weld Neck Spec=150

QUESTION: Is there more than one factor that serves to produce the above error message?

Most likely there is a size entry missing somewhere, or dimensions that do not work out correctly. It looks like you are placing a reducing flange ?

Vanman,

You are correct: the particular specification set up had no 1-inch size. This initial setup was an attempt in transferring data more or less "from the hip" / without in-depth study.

The better way:
I am following a printed copy of the tutorial video on the "Specifications Editor" by Mr. Tony Horn with solid success.

I look forward to helping others as I gain experience just as you and others have and are now helping me.

P.S.: This is even of greater value now that our company is off the maintenance support plan officially for the foreseeable future!