How does the Project Identifier attribute work? I have pointed it at an attribute in my title block in I-Configure using the Drawing Setup Tool, but can't get anything to appear on the iso. I am assuming this value comes from the ProjectName property of the I-config project. I even tried setting a default value for Project Identifier in the Project Defaults, but still no luck.

Using CADWorx 2019

Thanks

I believe you can use the I-config Project defaults, but always foud it easier to use the ISOGENPROJECTDATASETUP, this get saved to the CFG file.

Also are you mapping this to an actual block attribute or are you just using old fashioned positioned text ?

I was trying to map using drawing attributes and positioned text in the Drawing Setup Tool. What is the best way to handle it?

Where is ISOGENPROJECTDATASETUP?

Oh, I see now it's a command rather than a variable. Thanks

If you havent seen ISOWorx, it is worth a look as an easier alternative to filling out Attributed Title blocks from ISO
https://www.ecedesign.com/ece-software/isoworx/