For bolts with nuts, etc., is there a convenient method to list the quantities as "HEX BOLT WITH HEAVY HEX NUTS" instead of the default "Sets"?

TWO GOALS:

1.) I am trying to better understand how to adjust the ISOGEN settings as well as...

2.) ...mimic the overall look of an experienced piping designer's generic CAD-generated piping iso's.

Thanks!

You can look at BOMBOLTCONTROL in the CFG. I typically have mine set to 1. and then the isogen atext -538 set to ?x?

This is very enlightening!

It is not lost how much time you are saving me and, after plunging myself into only basic ISOGEN setup, realizing the depth of knowledge you possess.

I am grateful.

BomBoltControl=1
I have even gone through our bolts to account for washers and sickout length per client specs.