Dear All,

That's my first post on this forum, and I would like to take this opportunity to say Hi to whole community

I've got a question to CAESAR II experts:

I need to develop a pipe stress analysis for exhaust system pipeline which is supported with Rubber Design Stabilizers. See pic. below.

stabilizers:










How would you define restraints in Caesar II to simulate this situation in proper way?

So far I was familiar only with typical supporting for steel and GRE pipes with clamps - there was no need to use any more advanced restraints than typical rest, guide and limit stop combinations.

I would really appreciate any advices.
Thank you in advance.

Best regards,
Kajetan