Dear all,
I prepared one stress model which is very big. While running the model I am getting problem in iteration. For that reason I break the model into two parts.
After breaking the model into two parts, the end point of 1st part will be the start point of the second part model.
For more clear i would say my 1st part model starts from node 10 and ends with node 800. Second part model start with node 800 and ends with the node 2600 (which is the end of the model).
My question is while running the each model how should i end the Node 800 and for the second part how should i start the second model?
As a whole model at node 800 i have used one Restraint that is +y. so which type of restraint i will use now at node 800 after breaking it into 2 parts?
Shall i use anchor? Or else please clarify?
I hope my question is clear. Please tell me the procedure.
Thanking you all.
Please help me in sorting out my problem.