I have been provided with a Caesar II ver 4.40 model that uses 2 codes IGE/TD/12 & B31.3 so I can verify the loads at the Termination point of our design.
This model apparently runs fine on ver 4.4 but we only have version 5.
After extending the model on our side of the termination point (all to B31.3) I did an error check which came up with a number of 187E, 191E & 192E error messages on the existing IGE/TD/12 part of the model.
Has Caesar changed the way it checks intersections between versions 4.4 & 5.0 as I have been assured that the model has been run OK or are these error codes due to modeling errors.
The only data fields on the SIF Aux. Input is the node number & intersection type am I now expected to work out & fill in the other variables?