Hi,

We've never had this issue with Ver. 2018 but with new Ver. 2019 we are getting following error during the API 661 analysis.

When Table 4 Multiplier value is set below 2.0 the allowables in the output reflect this multiplier. However when we apply higher factor (for example 3.0) it generates warning message in the event log showing
"Factor has been reset to 1.0 for calculations".

Could we run the analysis with higher multiplier without the software self-resetting the factor to 1.0?

Thanks,

Please file an SR on Smart Support about this. We can get this changed with the first update to v.11 (2019).