Hi experts,

Can anybody pls tell me that what %age needs to be inputted in caesar ii input for mill tolerance (0.3mm) of pipes that are made from plate?

mill tolerance is used only in the minimum wall thickness check. It does not affect load or stress

Yes, you are right.

However, my query is what %age need to be input in caesar for mill tolerance of 0.3mm?

You can simply put % in te CAESAR II as '0.3mm / plate thickness * 100 %'

but what's the point?

It's not the worst of ideas to have CAESAR back up previously established wall thickness calculations, especially in early design, when you might not have a piping specification in mind.

However, to input mill tolerance as a flat measurement, you currently have to input each mill tolerance individually as a percentage of the wall thickness in question.

Perhaps in a future update, we can type in 0.3 mm or 0.0625".

Would you believe Version 11 ...