The dynamic results are not zero .
Other subject in the same dynamic example,
Reading the (OCC) Max.Response results I can see in the top of report " Highest Stresses (N/mm2)" Code Stress 125.3 @Node 270, after Bending, etc. OK! It means the maximum code stress happens in the node 270 and have the value 270 N/mm2, OK!
In the next lines below these information are presented the nodes in sequence with the results of stress and their time step.
But are presented two lines to each node with different results ( time steps differents ), question I should not find only one line of results (maximuns) and in the node number (270) where occurred the Max.Response I should not find the result presented in the top (125.3)? but other result is shown and different from the top ?
Would be an interpretation problem or I forgotten some detail ?
Thanks
yyyy