Hello,

I have been getting an error saying their is a mismatch in the region of 4 metre at certain nodes. I have checked all of my inputs and have found them to be in order. Additionally the scale of the mismatch suggests that it is not an input error.

Is there any reason for this error to occur. Your help would be highly appreciated .

Thank you

I think you just didn't find it yet.

Do you have any CNodes? They have to be right.

Also check the added nodes around bends to confirm they are not repeated elsewhere.

You'll get more help if you supply the data.

I was hoping it could be something else . I have quite a few CNodes but I did check them. I guess I will check them again.