Hi Seniors,

Good Day to All,

I need a quick guidance to setup my CAESAR configuration.
Basically for Code Compliance, Load Sustained combined with Occasional as per ASME B31.3 is as much as 1.33SH.

But when i generate my stress summary at Caesar my code Compliance value for Sustained combine Occasional is about 1.42Sh where is not 1.33Sh.

Where shall i configure this formula so that my analysis follows as per ASME B31.3 Standard.

Thank You,
P.S.Naveen

Something's not right, CAESAR II is not using 1.42Sh. Open a Support Request on SmartSupport and send in your job files.