Thanks for your Quick response Mr. Mandeep singh
I feel CAESAR-II is one of the Very Good tool for using the Codes that is why I taken output report from CAESAR-II. Just I need clarification only.
1. In PD5500 ANNNEX, Rho = (d/D)*Sqrt(D / 2*eas))
From this Rho is computed that is ok. But in CAESAR-II how the remaining two values are came from (curve 1 & curve 2). How these values are taken from these curves. (please provide REF. for the curves)
2. In drawing page, I didn’t find any drawing of the VESSEL-NOZZLE to check the forces direction and at what points (A, B, C) are taken on the VESSEL-NOZZLE drawing for evaluating stresses. Because I think in PD5500 calculations are based On QUADRANTS Q1, Q2, Q3, & Q4.( IN/OUT) . BUT where these point A, B, C? (output of Caesar-ii in finding intermediate values table) (please provide REF. for calculation of intermediate values table in code PD5500)
Please correct me if I am wrong.
Thanks In advance
_________________________
Thanks,
Durga