Just started using build 5.30.03
I find that pressing the reset plot button causes the view point to zoom right up close to the first element, as if my nose is on the pipe and it fills the whole screen. Anyone else getting this behaviour?

OK is anyone NOT seeing this?

We're looking into it.

I'm getting the same problem. for it to work properly it seems like i have to enable Reset View. Or just use Zoom Extents.

In fact goes to 0,0,0.

Is there any way to turn off "Zoom Extents" after I place an element or change somthing in the model? Every change I make to the model results in a zoom extents.

Deselect this item (it's also on a toolbar; it is automatically turned off once you close and reopen the input session):

Thank You So much!

The originally reported issue has been fixed in an older service pack for 5.30/5.31.