Dear expects,

In static output process which standard report can be check first, second, third and viceversa with reference to load case analyzed.

I am new in caesar stress analysis i need the basic.

regards,
kumar.s

You can 'check' all that you need. You don't have to review one at a time.

Dear sir,

I was understand, it should be check all the standard reports, but which one check first to withstand the sustained load.

eg:In (sus)w+P1 code compliance or streses or restraits or any other. like all the operating and expansion condition.

Please help me.

regards,
kumar

Kumar,

I usually check stresses, then displacements (for missed connections/restraints), then restraints (nozzle/support forces). But this can vary depending on if it's a simple or a more complex system

As indicated above, what you check first really depends on the job and the analysis. Usually I check displacements and restraints first - to make sure these all make sense, then I look at the stresses. Similarly, if the model has spring hangers, I usually check that report first.