Hello,

I am trying include a caesar file inside of other, but show me a message "ERROR--Units incompatible with file" I am using the same unit files in both calculation, and convert the both files using the same unit file... So I don´t know what happen. With version 5.2 or 5.1 never I was that problem, with 5.3 version I can´t do it that.

My current version is 5.3 built 101122.

I have problem too when renumber the nodes, just change the node of first of fourt restriction.

Please any person could help me???

Regards,
GS.

Open a Support Request (SR) on eCustomer and send your job files in so Support can review this.

Dear Richard, where can I open a SR... I was explore the http://www.coade.com/Default.aspx and I can´t found the SR...

Fix to this issue:

Remove "Uniform Loads" definition from both files, save each again. Then attempt to combine using 'Input Piping Files' tool. Once combined, then go back and re-enter your Uniform Loads definition once again.

This worked for me, as I had some seismic loadings specified as Uniform Loads on my model. I recieved this fix from Loren Brown at Intergraph.

No need for this work-around now. This incompatabilty has been corrected in SP-2.