I'm new comer on CII 5.20. I need to check the flange leakage check by using Peq. I checked on Flange and select T1 on load case option. But the flange leakage report is not contain data. Results are not shown.

Please advise.

Make sure (back in the input, on "Special Execution Options") that you have checked the checkbox to "Print Forces & Moments on Rigids".

Hi All,
I am doing analysis for steam turbine inlet nozzle.
This turbine is existing one and owner want to do analysis for inlet nozzle.
But when I read NEMA 23,It says we need to combined all nozzle for analysis.
please help me for this?

waiting fro reply ?

1. When you start a new subject, start a new thread. Don't tack you question onto an existing thread.

2. To satisfy NEMA SM-23 requirements you need at least loads on suction and discharge nozzles. You could consider compliance with the first part only of NEMA, para 8.4.6.1, which deals with load limits on individual nozzles.