The 'input-echo' for a buried model shold allow listing of the soil properties used in different sections.

Also, the information (e.g. virtual anchor etc) that comes up during 'convert-model',should be retreiveable at the output module.

Please consider.

Agreed.

How to check the Soil Properties that you used after converting the file? This is for the stress checker.

How to check the Soil Properties that you used after converting the file? This is for the stress checker.

Get the input file and the buried file together. Load the input file, then run the buried modeler, and you will see the inputs used to create the buried file. If the analyst modified the buried file after it was created they must inform you of the changes.

There isn't a practical way to work backwards from the buried output to determine soil parameters.

Actually you can select the "unburied model", then go to the "Buried Pipe Modeler" and review the soil properties. This is the procedure you would follow if your GeoTech guys change the data on you.