Hi friends,

can anybody tell me exactly what is difference between following factors (used for stress analysis)

1) Flexibility factor
2) Stress Intensifcation Fcator
3) Correction Factor
4) Reduction Factor

Thanks

Searching this Forum turns up this post .

Hello Bajwa,

Please go here

http://www.coade.com/cgi-local/ultimatebb.cgi?ubb=get_topic;f=1;t=001304

to find additional discussion of your question.

Regards, John.

:rolleyes: :rolleyes: :rolleyes: :rolleyes: :rolleyes:

Just send me your work I will be glad to do all of it for you for free....

Have you ever considered reading a code book or the CAESAR Manuals? Or do you prefer to annoy me with questions which should not be asked?

bajwa,
bends tend to ovalize to create flexibity which is determined using bend radius,pipe radius & thickness.
stress intensification factors were determined using fatigue analysis(7000 cycles normally)of inplane and outplane bending of pipes and finally they have derived an equation.
U can find these equations in B31.3 APPENDIX D.

arun,

No doubt you understand the issue but you did not quite get it right in your posting.

Anyway, this discussion moved to the end of this thread:

http://www.coade.com/cgi-local/ultimatebb.cgi?ubb=get_topic;f=1;t=001304

It is time to lock this thread and move along.