Is there a way to enlarge the print area in plot.
Seems there is alot of space not being used when I print my ISO.I use zoom extents.

What version of CAESAR II are you using?

Are you printing from the input or the output, or in the case of Version 5.00, from the ISOGEN interface?

Can you fax us an example of what your end result is (281-890-3301)?

Version 5.00.2 Build 60301
I am printing from the Output in 3D Plot.
Will fax an example.

The Window contents are rescaled, by Windows, before sending the data to the output device. Your fax shows that "axis compass" at the left margin, indicating the plot took the full width of the page.

What happens if you change the Window dimensions, so that it is higher than it is wide?

What happens if you zoom (using the rubber-band box) on the model, then print?

I printed again using output in both Portrait and Landscape.
I then printed in rubber-band box of model in both portrait and landscape.
Each time the ISO was larger in Landscape.
Will fax latest prints now.