Hello !
I am new user of Caesar II and I have a doubt about one feature when I use the StressIso, in "annotations" I selected all nodes (using shift key to be faster ) but in the drawing I noticed that the bends are presenteds with 02 segments of 45 degrees (including the respective dimensions )instead a only 90 degree bend.
Returning to "annotations" I started to remove all intermediate nodes of the bends and the drawing presented with 01x90 degrees bend, OK! but are not there other way to make this ( more easier without the need to remove one by one intermediate nodes )?
Thanks

No, because in order to put the node labels on the drawing, the node point must exist on the pipe.

Yes, it's easy to select all nodes, but not quite as easy to deselect the bend intermediate nodes, unless you write a program to take care of it. In my previous project, we had to utilize isogen for our report. In my program I bypass selecting the node numbers using Isogen. Instead, I generated the PCF code for the node number annotation.

One way to get around your issue is by having a list of node numbers to not be annotated (the bend intermediate nodes). And then remove it from each PCF programmatically (you must recognize how the annotations look like in the PCF). Getting the node numbers of the bends should be as simple as copying it from the input list, or input echo.

It's probably only worth the programming effort if you're dealing with a large project, having lots of large models.