Dear Sir
In the Unit file (*.FIL),if we set the different units for the pressure (eg.bars)and for wind pressure(N/MM2)..After make static run,In the static load case ,the lable on the USER WIND profile shows the line pressure units (bars) which supposed to be wind pressure units(N/MM2)...However the output value is correct...Only problem of graphical mismatch...
if any one experienced this problem.??..this may lead unnecessary misunderstanding for the user. By seeing the lable of wind pressure unit in lable , user may change wind profile value accordingly hence the result will be different
Some one can advise on this issue...
Regards
Sha...