Dear Sir,

I have 3 to 8 Springs in my Calculation and i want to block

(make it as rigid support) 2 springs of the total 8 springs in

particular condition .

It can be done by taking out spring in that location and

putting a rigid restraint for that 2 springs but Is there

option to make it as rigid support in hanger data table.

You may define it as user defined spring & put infinite value (1e 12 N/mm) in spring rate & very small preset load (say 1 N). This will simulate the blocked spring (or a rigid restraint) but frcition effects will not be considered.

I guess you can't alter the spring tables in Caesar.

Hope this is of some help.

The bigger issue is the statement "I want to block 2 of the springs in a particular condition." I take this to mean that the spring state (flexible or rigid) varies by load case. You can't do that in a single model in CAESAR II, with only "some" of the springs..

If it's OK with you, you can lock ALL springs by a single Load Case Options switch.