Hai dears,
Please help me in solving this error problm
When i am submitting to to Batch Run, it shoeing some errors which i given below

"Bend angle Specified for the bend element 35-40 is within 5.00deg of the bend far end point. Either use the bend far end point,node 40,or move the specifird node more than 5.00 deg away from the end point"
I modelled a bend from a node 35 to 45, the bend radius is 2286mm and bend angle 16.918.
I cant understand the meaning of the error, if any body can solve this please share to me.

You can control how close bend nodes are via the Configuration. However, I suspect a small error in your model. Open a Support Request in eCustomer and send in your model so we can check it out.

Dear,
yes you are right, now i solved it.
Thank you