My Piping Spec Std is Set to DIN; modeling my piping in mm. Valve & Flange set to Crane.VHD. I also tried CADWORX.VHD under the configuration Setup tab; When I try to use the V/F Database on the "Input" menu I get a message saying: No database values. ?
So, now I have to manually enter in the weights and lengths for the valves and flanges.
Registered: 12/13/99
Posts: 6226
Loc: Houston, Texas, USA
That should work fine - I just did it with a 150# flanged gate valve. It dropped in a lenght of 501.65mm and a weight of 1734.8N. (I used a nominal pipe diameter of 200mm.)
Is your CAESAR II installed locally or on a network drive? What Version are you using?
_________________________
Regards, Richard Ay - Consultant