Dear all
I am using CAESAR II 5.1 for analyzing above ground pipeline as per ASME B31.8, and the output results for the allowable expansion stresses are always zero (Note: Not the allowable stresses field in the operation load case code compliance value, it is the allowable stresses field in the expansion load case).
I know that this subject was discussed before in the forum , and if i can recall my memories, i remember that it is been told that the output will be repaired in the next version of CAESAR .
The problem that i am unable to locate where this subject was discussed, and if any body can help, i will be appreciated.
(Note : the "restrained as 833.1" field is off in the inputs)
Regards
Ahmad Akila