I am having a problem getting bends to show up in my model, do elements need to be entered one after the other to get a bend? The way I have built up my model means that in some sections the elements arent entered this way and the bends are not being shown. Is there any way around this?
Registered: 12/13/99
Posts: 6226
Loc: Houston, Texas, USA
The only modeling restriction in CAESAR II is that the two elements that make up a bend must be entered back-to-back, sequentially, one-after-the-other. There is no way around this.
_________________________
Regards, Richard Ay - Consultant