Dear Sir,

How can we transfer C2_4.50 file to C2_5.10 for create isometric drawing?

Thanks, in advance.
New Piping Engineer.

maxmang,

What do you mean by transfer?? If it means opening, to C2_5.10 I think you can open the file directly. That is based on my experience in C2_5.0 but if that is not possible in C2_5.10 you can convert the file to neutral file.




YOCH

ya correct yoch 25. first u must convert those files into neutral file.


you can easy to open lower version into higher version .
it is in Tools- external interface- neutral file.

I mean that when we can open C2_4.50 file in C2_5.10, so we can create isometric drawing. (no need to any more setting )?

When moving "up" in versions you don't need to do anything - just open the file in the appropriate input module and you're done.

As far as the Isometric drawings go, if you plan on including any output data you will have to re-run the job in the newer version.

In this matter, I got the problem that when I open C_4.50 file for re-run and create Isometric drawing---> shutdown in Iso module only (Spread sheet is normal) but when I create new file from C_5.10 for run analysis and create isometric drawing--->OK

Regards,
New Piping Engineer.