Hi,
Have anybody encountered operating displacement more than the specified restraint gaps? I can not find where the problem is but I think its strange. How can I correct such kind of problem? Any help would be appreciated.

Are you sure you're looking at the OPE case, and not the EXP case?

If you are looking at the OPE case, was there a really flexible stiffness assigned at this node? What about a CNODE there?

Yes it is in Ope Case. No Flex stiffness and no CNOde. No error warnings.
My model consist of 6 piping model attachment. When I only attached 3 models all the movements looks fine but when I attached all 6 it gives me strange movements. Is CAESAR II capable to handle such big model?

Yes CAESAR II can handle this. I have not idea what could be wrong. Send your job file(s) in to techsupport@coade.com.

Hi,

Check config setup/computational control/ and look at the restrain stiffness value. If it is default(i hope)the value will not be more than specified in the input.Otherwise it may have more than that specified.

You can check it out and give me your feedback.


regards

Sha..

could you check filter in output?
I think your caesar file applicate is more than a little displacement.
so you should check filter system in output.