In caesar when we define a spring hanger as single spring with calibration load=3000 Kg & Spring rate = 32 Kg/mm or spring with cal. load= 1500 Kg and spring rate = 16Kg/mm and no of springs we define as 2. Will the functioning of definition of both the spring will be same or there will be some difference??

Dear sir,
Two spring units will be used in vertical riser, each supporting one-half of the total load. Please refer this following document page no 13 under titled selection of the proper hanger.
www.anvilintl.com/db/datasheets/Pipe_Hanger_Design-05.pdf

regards
G.P.SENTHIL KUMAR
DEVELOPMENT CONSULTANTS PRIVATE LIMITED
CHENNAI.

It's same.

I mean when we use in caesar we define spring hangers 2 numbers and cal. load & spring rate for indvidual hangers. But we can also define the hanger load in total and specify the spring for that cal. load. I want to know whether caesar works down same hanger calculation results for both types. May be Mr.senthil misunderstood my question

Why don't you make a trial run and see for yourself?

Regards