Dear friends,
I am looking for a supporting reference for difference equipments.
best regards

Can you narrow this down some?

Dear richard,
i want to put supports(slide, guide,anchor,..) for pipes which connected to some equipments like pump,turbine...
but i need a standard reference for this job.
for example for a pump(hot or cold service)what type of support(slide,guide,...) i must put in suction or discharge lines??
truly yours
ozm

ozm,

Although many are similar, most E&C companies and operators use their own 'in-house' Pipe Support Standards. Your specific pipe support requirements will vary based on your equipment, temperaure, material, pipe sizes and configuration. The Piping Engineer assigned to your job will be best source to address your questions.

Good luck,

kevin,
i am engineer!
i am talking about standardization,
means best
thanks

ozm

Your question has no real answer.

Each configuration is supported on its own merits
which is where good design is important
'THE PIPING GUIDE' has examples of how to support typical process set ups.

But your question is to big to answer.

I would say however, that the fact YOU are asking the question means you should seek proffesional expertise from elswere (consultants)

(WE) would burn alot of hours creating such standards which i would question as to their usabillity

Thanks,
but piping guide is not a complete reference for supporting,
unfortunatly i think we have not a standard reference for supporting, may be in future...
regards
OZM
if you cant convince,will be confuse!